Sample Concentrator with Visible Block

The nitrogen sample concentrator is used for concentrating or preparing samples in batches. It is used in processes such as drug screening, hormone analysis, liquid phase and mass spectrometry in the analysis of sample  preparation. It works by blowing nitrogen in the surface of the sample which is being heated to accelerate evaporating and separating the solvent in the samples without oxygen. Instead of the rotary evaporation instrument, the  nitrogen sample concentrator can efficiently concentrate dozens of samples simultaneously.The sample surface in the tube can be observed while concentrating.

Supplied with one BT1603-B 12 x 12mm hole block. Additional blocks are sold separately (See Related Products).

A gas flow control valve is also available for preceise control of gas flow. Item sold separately.

Features

• Works by heating with dry bath in the bottom and nitrogen blowing on the surface which accelerates liquid evaporation and sample concentration
• Adjustable height of air chamber plate. Standard needle length is 150mm
• Sample surface in the tube can be observed while concentrating, a unique characteristic
• Independently controlled gas needle. Separate blowing and flow regulating of each needle are available to avoid gas waste
• The instrument can be put into a ventilation cabinet when the concentration sample is toxic solvents
• Built-in overheating protection, automatic fault detection and fault alarm features
• LED displays temperature and time. Operation is simple and convenient. Can be set for continuous operation.
• Works by heating with dry bath in the bottom and nitrogen blowing on the surface which accelerates liquid evaporation and sample concentration
• Standard configured air cavity and adjustable bracket.

Specifications

• Temp control range: ambient+5°C-150°C
• Temp setting range: 5°C-150°C
• Temp stability @ 40-100°C: ±0.5 °C
• Temp stability @ 100-150°C: ±1 °C
• Block temp uniformity @ 100°C: ±0.5 °C
• Block temp uniformity @ 150°C: ±1 °C
• Temp display accuracy: 0.1°C
• Heating speed: ≤30 min (40°C to 150°C)
• Time range: 1min-99h59min or continous
• Needle plate max. lift stroke: 285mm
• Gas-in joint outer diameter: ɸ7mm
• Nitrogen pressure:  ≤0.1MPa
• Nitrogen flow rate: 0-10L/min
• Needle length: 150mm
• Sample capacity: 1 standard visible block
• Voltage: AC110V or AC220V, 50/60Hz
• Power: 400W
• Fuse: 250V,3A/6A, ɸ5x20
• Dimension (WxDxH): 220x260x 525mm
• Weight: 5.8kgs

Download Manual

Additional Blocks (see related products)